Have been working but a little slack on the documenting....... Finished multiple coats of poly on the floorboards and got them installed. I put a piece of aluminum sheet on the floor boards where my heels will hit. In my whole life I think I have only flown one plane that didn't have major wear marks from the pilot's heels and that plane I got to pick up from the factory. Moved ahead with the rudder pedal install and was moving right along until I got to fabricating the clip that goes over the wheel on the pedals. Not sure what the deal was with me but I think those were the UGLIEST clips ever made by man. There was no way I was going to install them. They were either too high or too wide at the top. So I went to the Kitfox Help Line (Debra, Heather and Nicky) and ordered another set of the stainless steel sheet to do it again. While I was waiting for the new stock, I decided to build a jig to help make these clips. Took a piece of plywood and cut two grooves the same width and depth as the stainless steel stock. Glued another piece of wood over the top of the grooves so that the stock would slide in. Measured and drilled where the holes in the clips should be when the clip was installed in the jig. I got the stainless from Kitfox today and made all four clips using the jig and am really happy with the fit and finish when installed on the rudder pedal brackets.